Old-fashioned English Custard Tart
This old-fashioned custard tart needs a thick, wobbly filling, so I've used a round tin with sloping sides and a rim, which gives a good depth. The nutmeg is very important to the flavour, so always use it freshly grated and grate it on to a piece of foil, which helps when you have to sprinkle it on quickly when it goes into the oven.
|Need help with conversions?|
|You will also need a 2 inch (5 cm) leaf cutter, a tin that has a rim and sloping sides (1½ inches/4 cm deep, with a 7 inch/18 cm base and a ½ inch/1 cm rim), lightly greased, and a medium-sized, solid baking sheet.|
This recipe is taken from How to Cook Book One.
To make the pastry, first of all sift the flour with the pinch of salt into a large bowl, holding the sieve up high to give it a good airing. Then add the lard and butter and, using only your fingertips, lightly and gently rub the fat into the flour, again lifting the mixture up high all the time to give it a good airing. When everything is crumbly, sprinkle in about 1 tablespoon of cold water. Start to mix the pastry with a knife and then finish off with your hands, adding a few more drops of water, till you have a smooth dough that leaves the bowl clean. Then pop the pastry into a polythene bag and let it rest in the refrigerator for 30 minutes. Meanwhile, pre-heat the oven to gas mark 5, 375°F (190°C) and pop the baking sheet in to pre-heat on the centre shelf. After that, roll the pastry out into a circle on a surface lightly dusted with flour, giving it quarter turns to keep its round shape; it's a good idea at this stage to put the tin lightly on top of the pastry – the size needs to be 1 inch (2.5 cm) bigger all round. Now transfer it, rolling it over the pin, to the tin, and press it lightly and firmly around the base, sides and rim. Now take a sharp knife and trim the overlapping pastry. Then press the rim of the pastry so that about ¼ inch (5 mm) overlaps the edge. Next, roll the trimmings and cut out about 24 leaves, making veins in them with the blunt side of the knife. Now brush the whole surface of the pastry case with some of the beaten eggs, arranging the leaves all around the rim, overlapping them. Brush these, too, with beaten egg. Now prick the base of the tart with a fork, then place it on the baking sheet and bake on the centre shelf for 20 minutes, until the pastry is crisp and golden. Check after 4 minutes to make sure that the pastry isn't rising up in the centre. If it is, prick it again a couple of times, pressing it back down with your hands. After 20 minutes, remove it from the oven, leaving the baking sheet there, and reduce the temperature to gas mark 3, 325°F(170°C). Now place the cream in a saucepan and bring it up to a gentle simmer, then whisk the beaten eggs and sugar together in a large heatproof jug using a balloon whisk – but not too vigorously because you don't want to make bubbles. Then pour the hot liquid over the beaten eggs, add the vanilla extract and half the nutmeg and whisk briefly again. Now place the pie tin back on the baking tray with the oven shelf half out and have ready the rest of the grated nutmeg on a piece of foil. Carefully pour the filling into the pastry case (it will be very full) and scatter the rest of the nutmeg all over, then dot with the softened butter and bake in the oven for 30-40 minutes, until the filling is golden brown, firm in the centre and slightly puffed up. Serve either warm or, as I actually prefer it, cold.
Return to Homepage
Visit the Delia Online Cookery School with Waitrose
Click here to go to Waitrose.com
Copyright © 2009 Delia Smith/New Crane Internet Limited, ALL RIGHTS RESERVED.
No recipes relate to this.
Most Popular recipes
Flavours of France plus win Le Creuset cookware
Win a new 2014 Leisure Cookmaster range cooker in time for Christmas
cups versus weights
04 Dec 2013 17:39
|Delia's live online Christmas chat||
This forum is now closed...
02 Dec 2013 08:24
04 Dec 2013 19:26
|Food and travel||
28 Sep 2013 09:20
04 Dec 2013 14:22
|Can Anyone Help?||
04 Dec 2013 21:11
28 Nov 2013 01:18
using the Kenwood patoto peeler
04 Dec 2013 17:42
04 Dec 2013 09:03